Toll-Free: 800.957.4390
Phone: 330.427.0125
Fax: 330.427.0800
Email: info@tsengineering.com

ST-700 Specifications

Vibratory Feeder Controls
Single Units (10 Amp Capacity)

The ST-700 Series of Controls are used to operate small vibratory bowls, storage hoppers and inline linear feeders. This control family is typically used on loads that run continuously, but can be demand cycled by a PLC machine control or parts sensor, which has its own built-in time delays and power supply.

· 120 Vac, 10 Amp Control features basic operation. Operates small Vibratory Feeder Bowls, Inline Feeders, and Storage Hoppers.

· Full Wave/Half Wave Output is Switch Selectable from 120 Pulses per second (un-rectified) to 60 pulses per second (rectified).

· All ST-700 Series Controls will operate on either 50 Hz or 60 Hz line frequency.

· A Run Interlock Input (Remote Hold) is provided so the control can also be turned On/Off, (Hold mode), by a PLC or other feeder control. Remote Hold can be controlled by an NPN track level sensor, dry contact closure or 5 volts RMS minimum to 120 volts RMS maximum (AC or DC) voltage input

· Phase Select feature enables which phase of the line voltage the controller triggers off of on the 30Hz and 60Hz frequency output selection only. This allows balancing of the source when multiple units are utilized

· Operate / Hold Out (Interlocking) This is a unit functional output of +5 Vdc indicating Operate mode and a 0 Vdc output indicating the controller is in Hold mode. This function is used not only for indication but also for multiple controller interlocking.

View printable version of this page